Table of Contents
Advertisement
EXi Program P0: Play
0–1: Main
0– 1b
This is the main page of Program mode. For a full
description of this page and all of its functions, please see
"EXi Program P0: Play" on page 173. This section describes
only the overview display, which differs for each individual
EXi.
0–1b: Overview and Page Jump
This part of the page shows an overview of the most
important settings for the Program's two EXi instruments.
The specific parameters will vary, depending on which EXi
are being used. The specific parameters for the MS-20EX
are described below.
The graphics give you a quick way to check all of these
settings at a glance. They also let you jump instantly to any
of the displayed parameters. Just touch one of the sections,
and you'll jump to the page containing its parameters. For
instance, if you touch the Filter graphic, you'll go to the
Oscillator and Filter page.
Tip: Pressing EXIT several times will always bring you back
to this page.
Oscillators and Filters
This section shows the waveforms for Oscillators 1 and 2,
and the cutoff frequencies for the Highpass and Lowpass
filters. Touch this area to jump directly to the Oscillators &
Filters page.
MG/EG/Mod
This section shows the waveform and frequency of the MG,
and the Attack and Release times for EGs 1 and 2. Touch this
area to jump directly to the MG, EG, & Modulation page.
EXi Program P0: Play 0–1: Main
Patch Panel
This section shows a miniature overview of the Patch Panel,
with its cables and jacks. Touch this area to jump directly to
the Patch Panel page.
EGs and LFOs
EG 3...6 Graphics
These show the shapes of the four multi-stage EGs. Touch
any of them to jump directly to the corresponding edit page.
LFO 1...4 Graphics
These show the waveforms and shapes of the four LFOs.
Touch any of them to jump directly to the corresponding edit
page.
Key Zone
Key Zone
This shows the key zones for EXi1 and EXi2, as set on the
Common section's Program Basic page, in relation to the
entire MIDI note range. The range of the 61-, 73-, or 88-note
keyboard is also shown, as appropriate.
Press this area to jump to the Program Basic page.
Common
The graphics along the right side of the screen show the most
important Common parameters, which are shared by both
EXi in the Program. This section will always show the same
parameters, regardless of which EXi are being used.
Common Voice Assign Mode
This shows the voice assign mode of the Program–either
POLY or MONO.
305
Advertisement
Table of Contents
