Korg KRONOS SGX-2 Parameter Manual page 583

Show Point [VJS, Vector EG Point 0...4]
You can view the volume and CC values for the current
position of the Vector Joystick, or for any of the EG's five
points. This selects the point whose values will be shown.
CC at Show Point [%]
This read-only display shows the volume values for the
current Vector point, as selected by the Show Point
parameter, above.
Track 01
Enable Song Vector CC
This controls whether or not the Track will receive the
Song's Vector CCs.
If this is On, the Track will receive the CCs, and the Track's
Program will respond to them according to its own AMS
settings.
If this is Off, the Track will not receive the CCs. This can be
useful if the Song's Vector CCs are causing unwanted
modulation, or conflicting with the Program's own Vector
CCs.
Enable Program Vector CC
This controls whether or not the Program's own Vector CCs
will be active.
If this is On, the Program's Vector CCs and Vector EG will
work as AMS sources, just as they did in Program mode.
The CCs will not affect any other Tracks, even if they are set
to the same MIDI channel.
Note that. in some cases, the Vector CCs may have been
used for modulating the Program's effects via Dmod. This
functionality is not carried into the Song; for modulating the
Song's effects, use the Song's Vector CCs instead.
If Enable Program Vector CC is Off, then the Program's
Vector CCs will have no effect. This can be useful if they are
conflicting with the Song's Vector CCs.
Tracks 02–16
The settings for Tracks 2–16 are identical to those for Track
01, as described above.
v 1–6: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 153.
• 0: Memory Status. For more information, see "Memory
Status" on page 637.
• 1: Exclusive Solo. For more information, see "Exclusive
Solo" on page 153.
• 2: Rename Song. For more information, see "Rename
Song" on page 637.
• 3: Initialize Song. For more information, see "Initialize
Song" on page 637.
• 4: Copy From Song. For more information, see "Copy
From Song" on page 637.
• 5: Load Template Song. For more information, see
"Load Template Song" on page 637.
Sequencer P1: EQ/Vector/Controller 1–6: Vector CC Control
• 6: Save Template Song. For more information, see
"Save Template Song" on page 638.
• 7: FF/REW Speed. For more information, see "FF/REW
Speed" on page 638
• 8: Set Location (for Locate Key.) For more information,
see "Set Location (for Locate Key)" on page 639.
• 9: GM Initialize. For more information, see "GM
Initialize" on page 639.
• 10: Copy From Combi. For more information, see
"Copy from Combi" on page 639.
[Off, On]
• 11: Copy From Program. For more information, see
"Copy From Program" on page 639.
[Off, On]
569