Program P6: Amp; 6-1: Amp - Korg KRONOS SGX-2 Parameter Manual

Program P6: Amp

These pages let you control the sound's volume (also called
"amplitude," or "amp" for short), pan, and the dedicated amp
envelopes and keyboard tracking generators. For instance,
you can:

6-1: Amp

6–1a
6–1b
This page controls the basic settings for the Amp section.
Here, you can:
• Set the initial volume level.
• Control the pan position and pan modulation.
6–1a: Amp Level
Amp Level
This controls the basic volume level of the STR-1, before
keyboard tracking, velocity, and other modulation.
The Control Surface and volume
You can also control the volumes of EXi 1 and 2 directly
from the Control Surface sliders. These volume levels are
separate parameters, in addition to the individual EXi Amp
Levels. To do so:
1. Press the Control Surface Timbre/Track button.
2. Move Slider 1 to set the volume for EXi 1, and Slider 2
for EXi 2.
MIDI and volume
You can control the Program's overall volume via MIDI
using both Volume (CC#7) and Expression (CC#11).
When used one at a time, the two controllers work in
exactly the same way: a MIDI value of 127 is equal to the
Amp Level setting, and lower values reduce the volume.
• Set the pan position and pan modulation.
• Control amp level and modulation, including keyboard
tracking, the amp envelope, LFO modulation, and AMS
control.
If both CC#7 and CC#11 are used simultaneously, the one
with the lower value determines the maximum volume,
and the one with the higher value scales down from that
maximum.
6–1b: Pan
Pan
[0...127]
This controls the stereo pan of the EXi. A setting of L001
places the sound at the far left, C064 in the center, and R127
to the far right.
When Filter Routing is set to Parallel, the two filters can be
panned separately (see "Pan" on page 284) and the STR-1
can create a stereo output. In this case, Pan steers the stereo
image while maintaining the relative volumes of the STR-1's
left and right outputs. For instance, as you move Pan to the
right of center, the STR-1's left output will start to move to
the right side, until at R127 both the left and right outputs
sound entirely in the right channel.
When this is set to Random, the pan position will be
different for each note-on.
You can also set this Pan parameter directly from the Control
Surface knobs. To do so:
1. Press the Control Surface Timbre/Track button.
2. Set the MIXER KNOBS switch to INDIVIDUAL
PAN.
Program P6: Amp 6-1: Amp
6–1PMC
[Random, L001...C064...R127]
291