041: Stereo Harmonic Chorus - Korg KRONOS SGX-2 Parameter Manual

Effect Guide

041: Stereo Harmonic Chorus

This effect applies chorus only to higher frequencies. This
can be used to apply a chorus effect to a bass sound without
making the sound thinner. You can also use feedback to turn
the chorus into a flanger.
Stereo In - Stereo Out
Left
High/Low Split Point
Right
LFO: Tri / Sine
CHORUS
Pre Delay [msec]
Sets the delay time from the original sound.
Depth
Sets the depth of LFO modulation.
Source
Selects the modulation source of the LFO modulation depth.
Amount
Sets the modulation amount of the LFO modulation depth.
Feedback
Sets the feedback amount for the chorus. Increasing the
feedback turns the chorus into a flanger.
High Damp [%]
Sets the amount of high-frequency attenuation for the
chorus.
High/Low Split Point
This sets the frequency split point between the low and high
ranges. Only the high range will be processed through the
chorus.
Low Level
Sets the low range output level.
High Level
Sets the high range (chorus) output level.
LFO
Waveform
Selects the LFO Waveform.
Phase [degrees]
Sets the LFO phase difference between the left and right. See
"Phase [degrees]" on page 923.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
942
Low Level
Chorus/Flanger
High Level
High Damp
Feedback
High Damp
High Level
Chorus/Flanger
Low Level
LFO Phase
[0.0...50.0]
[0...100]
[Off...Tempo]
[+/–100]
[+/–100]
[0...100]
[1...100]
[0...100]
[0...100]
[Triangle, Sine]
[–180...+180]
[0.02...20.00]
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
MIDI/Tempo Sync
Wet / Dry
BPM
Base Note
Times
Wet / Dry
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on page 921.
Type
This controls whether the effect uses its individual LFO, or
one of the Common FX LFOs. For more information, see
"LFO Type" on page 921.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
[Off...Tempo]
[–20.00...+20.00]
[Check-box]
[MIDI, 40.00...300.00]
[Individual, Common1, Common2]
[r ... w ]
[x1...x32]
[+/–180]