Korg KRONOS SGX-2 Parameter Manual page 561

Table of Contents

Advertisement

Input 1 & 2
USB 1 & 2
S/P DIF L & R
Bus Select (IFX/Indiv. Out Assign)
[L/R, IFX1...12, 1...4, 1/2...3/4, Off]
FX Ctrl Bus (FX Control Bus)
REC Bus
Send1 (to MFX1)
Send2 (to MFX2)
Play/Mute
Solo On/Off
Pan
Level
0–8b: Recording Level [dB]
These parameters are the same as in Program mode P0–
Audio Input/Sampling. For more information, please see "0–
8b: Recording Level [dB]" on page 21.
The final signal level when recording an audio track is set
by the P0– Preference page Recording Level setting.
Recording Level
The Recording Level setting applies to all of Sequencer
mode, and is not saved with individual Songs.
0–8c: Sampling Setup
Here you can select the source to be sampled, and the
method by which to initiate sampling.
Except for "Trigger," the following parameters are the same
as in the Program mode P0– Audio Input/Sampling page.
See "0–8c: Sampling Setup" on page 22.
Sampling Setup settings are maintained not separately for
each song, but as a single set in Sequencer mode.
Source Bus
REC1/2...3/4, Indiv.1/2...3/4]
Source Direct Solo
Trigger
[Sampling START SW, Note On,
Threshold, Sequencer START SW]
Specifies how sampling will be initiated.
Sampling START SW: Pressing the SAMPLING REC
switch will cause the KRONOS to enter sampling-standby
mode, and sampling will begin when you press the
SAMPLING START/STOP switch.
Note On: Press the SAMPLING REC switch, and then press
the SAMPLING START/STOP switch to enter sampling-
standby mode. Sampling will begin when you play the
keyboard.
You can also initiate sampling by receiving a MIDI note-
on message instead of playing the keyboard.
[Off, 1, 2]
[Off, 1...4, 1/2, 3/4]
[000...127]
[000...127]
[Play, Mute]
[Off, On]
[L000...C064...R127]
[000...127]
[–Inf, –72.0...+18.0]
[Audio Input1/2, USB 1/2,
S/P DIF L/R, L/R,
[Off, On]
Sequencer P0: Play/REC 0–8: Audio In/Sampling
Threshold: Sampling will begin automatically when the
input level exceeds the specified Level value. For more
information, see "0–8c: Sampling Setup" on page 699.
Sequencer START SW: Press the SAMPLING REC switch
and then the SAMPLING START/STOP switch to enter
sampling-standby mode. Then press the SEQUENCER
START/STOP switch to begin sampling. Use this when you
want to resample the song playback.
To stop sampling, press the SAMPLING START/STOP
switch once again. Sampling will also end if you keep
sampling until the time specified by "Sample Time." For the
procedure, see "Trigger" on page 699.
Metronome Precount
Threshold Level
When sampling with Trigger set to Threshold, this specifies
the level at which sampling will begin. This can be set only
when Trigger is set to Threshold. See step 3 of the Trigger
Threshold procedure.
Save to
For more information, please see "Save to" on page 24.
Mode (Sample Mode)
For more information, please see "Mode (Sampling Mode)"
on page 24.
Sample Time
For more information, please see "Sample Time" on
page 24.
Sample to Disk
This sets the bit depth for sampling to disk. For more
information, please see "Sample to Disk" on page 25.
v 0–8: Page Menu Commands
You can use a front-panel shortcut for menu items 0-9. For
more information on these shortcuts, see "ENTER + 0-9:
shortcuts for menu commands" on page 153.
• 0: Memory Status. For more information, see "Memory
Status" on page 637.
• 1: Exclusive Solo. For more information, see "Exclusive
Solo" on page 153.
• 2: Rename Song. For more information, see "Rename
Song" on page 637.
• 3: Initialize Song. For more information, see "Initialize
Song" on page 637.
• 4: Copy From Song. For more information, see "Copy
From Song" on page 637.
• 5: Load Template Song. For more information, see
"Load Template Song" on page 637.
• 6: Save Template Song. For more information, see
"Save Template Song" on page 638.
• 7: FF/REW Speed. For more information, see "FF/REW
Speed" on page 638
• 8: Set Location (for Locate Key.) For more information,
see "Set Location (for Locate Key)" on page 639.
• 9: GM Initialize. For more information, see "GM
Initialize" on page 639.
[Off, 4, 8, 3, 6]
[–63dB...00dB]
[RAM, DISK]
[L-Mono, R-Mono, Stereo]
[min sec]
[16-bit, 24-bit]
547

Advertisement

Table of Contents
loading

Table of Contents