Chapter 2: Setup And Configuration; Unpacking The Fixture; Save All Shipping Materials; Figure 2-1 Removing And Replacing The Bezel - High End Systems x.Spot User Manual

Chapter 2:
Setup and Configuration

Unpacking the Fixture

Unpack the x.Spot fixture and verify that it is undamaged. Inspect both the outside of
the fixture for physical damage and the optical assembly for damage to glass
components. To access the optical assembly, loosen the three (3) captive screws on
each side of the fixture head. Remove the bezel by lifting away from the base and
toward the lens, see Figure 2-1.
If there is damage, notify both the shipping agent and the sales agent immediately.
When replacing the bezel, ensure that it is fitted securely in the yoke channel on both
sides of the fixture as shown in Figure 2-1.

Figure 2-1 Removing and replacing the bezel

Captive Screws

Save All Shipping Materials

Do not discard the shipping carton and packing materials. The carton and packing
materials are specifically designed to protect the product during transport.
High End Systems® assumes no responsibility for products that are damaged during
transport. Return a product for repair in its original shipping carton and packing
materials.
x.Spot ™ User Manual
Bezel channel in
yoke arm
Setup and Configuration
2
2-1