A18 Cpu Turn-On Test; Failure Symptoms; A2 Display Not Functioning Or A2 Display Not Functioning After Turn-On; A18 Cpu Fails To Complete The Turn-On Check - Keysight Technologies E8257D Service Manual

Troubleshooting
A18 CPU Turn–On Test
A18 CPU Turn–On Test
If it is determined that the A18 CPU is defective but still functions, it is
recommended that you back up the calibration data in the CPU prior to replacing
it. To back up the calibration data, see
At turn–on, the A18 CPU is designed to complete a series of operational
checks. If all power supply voltages are present and the A18 CPU is working
correctly, the operational checks are completed. Errors are reported if the
A18 CPU has problems identifying other assemblies or communicating with the
backup memory located on the A31 Motherboard.

Failure Symptoms

— display is not functioning
— CPU fails to complete the turn–on check and does not reach normal LCD
— display is not functioning after turn–on
— unable to control signal generator from front panel
— error message is displayed after turn–on
A2 Display Not Functioning or A2 Display Not Functioning After
Turn–on
Refer to
A18 CPU Fails to Complete the Turn–On Check
1. Turn power off and remove outer and inner covers.
2. Turn on power and verify A18 CPU LED DS9 (+3.4 Vdc) and DS10
Table 1-2
Connector P222
(A31 Motherboard)
Pin 45–48, 95–98
Pin 49, 50, 99, 100
3. If the voltages are present on connector P222, turn power off and remove
22
operation
"Front–Panel Display Assembly Troubleshooting" on page
(+5.2 Vdc) are on. If either of the LEDs are off, check the voltages in
1-2. Refer to the illustration in
Errors" on page 76 for LED locations.
the A18 CPU.
E8257D/67D, E8663D PSG Signal Generators Service Guide
"CPU Data Backup" on page
"Self–Tests 11xx: A18 CPU Self–Test
Supply Vol tage
+3.4 Vdc
+5.2 Vdc
24.
30.
Table
Acceptable Range
+3.4 ± 0.07 Vdc
+5.2 ± 0.1 Vdc