Module Parameter; Refresh Settings - Mitsubishi Electric MELSEC iQ-R Series User Manual

10.2
Set the module parameter. The module parameter has the following settings.
Module parameter (Motion)

• Refresh settings

Module parameter (Network)
• Required settings
• Basic settings
• Application settings
*1 For details, refer to CHAPTER 2 "PARAMETER SETTINGS" in the following manual.
MELSEC iQ-R Motion Module User's Manual (Network)
Select the module parameter from the tree on the following window.
Navigation window  "Parameter"  "Module Information"  Target module  "Module Parameter"
Refresh settings
Configure the setting to transfer the values in the buffer memory of the Motion module to devices or module labels in the CPU
module. By configuring these refresh settings, reading the data by program is not needed.
Select the transfer destination from the following at "Target".
• Module label (Page 361 Module label)
• Refresh data register (RD) (Page 361 Refresh data register (rd))
• Device (Page 361 Device)
Module label
Transfer the setting of the buffer memory to the corresponding module label of each buffer memory area. Items of all axes are
automatically set to "Enable" by setting "Feed current value" of the axis 1 to "Enable".
Refresh data register (rd)
Transfer the setting of the buffer memory to the refresh data register (RD) of the CPU module. All transfer destinations are
automatically set by setting the top device to "Top Device Name".
Device
Transfer the setting of the buffer memory to the specified device of the CPU module. The devices X, Y, M, L, B, D, W, R, ZR,
and RD can be specified. To use the bit device X, Y, M, L, or B, set a No. which is divisible by 16 points (example: X10, Y120,
M16). The data in the buffer memory is stored in devices for 16 points from the set No.
Ex.
When X10 is set, data is stored in X10 to X1F.
Downloaded from ManualsNet.com

Module Parameter

*1
search engine
10 PARAMETER SETTING
10.2 Module Parameter
10
361