[Md.24] Axis warning No.
Whenever an axis warning is reported, a related warning code is stored.
• This area always stores the latest warning code. (Whenever an axis warning is reported, a new warning code replaces the
stored warning code.)
• When "1" is set in "[Cd.5] Axis error reset", the axis warning No. is cleared (set to "0").
• Monitoring is carried out with a hexadecimal.
Refresh cycle: Immediate
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 401 Axis monitor data
[Md.25] Valid M code
This area stores an M code that is currently active (i.e. set to the positioning data relating to the current operation).
"0" is stored at PLC READY signal [Y0] OFF.
The value stored is 0 to 65535.
Refresh cycle: Immediate
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 401 Axis monitor data
Downloaded from
ManualsNet.com
search engine
12 DATA USED FOR POSITIONING CONTROL
12.7 Monitor Data
12
489