Table 75: Wbm "Routing" Page - "Ip-Masquerading" Group - WAGO Compact Controller 100 Manual

146 Appendix
"Dynamic Routes" Group
All default gateways received via DHCP are displayed.
Default gateways configured via DHCP are given the metric value 10, which
means that they are normally used before the statically configured default
gateways.
Each dynamic route has its own area in the display. If no dynamic routes are
received via DHCP, "(no dynamic route)" appears.
"IP-Masquerading" Group
Each entry has its own area in the display.
Table 75: WBM "Routing" Page – "IP-Masquerading" Group
Parameters
Enabled
Interface
Click the [Submit] button to apply the changes. The changes take effect
immediately.
Click the [Add] button to add a new entry. The change takes effect immediately.
Click the [Delete] button to delete an existing entry. The change takes effect
immediately.
An entry is only transferred to the system if "Enabled" is enabled in the "General
Routing Configuration" group. This allows you to configure a default setting that is
not applied until the general switch-on.
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
751-9301 Compact Controller 100
Explanation
Specify whether IP masquerading should be used.
Disabled IP masquerading is not used.
Enabled IP masquerading is used.
You can select the specified name of a network
interface. Alternatively, selecting "other" allows you
to specify any network interface name.
WAGO I/O System Compact