Setting The Ip Address Via The Wbm - WAGO Compact Controller 100 Manual

84 Commissioning
8.3.4

Setting the IP Address via the WBM

You can change the IP address of the controller directly via the built-in Web-
Based Management without additional tools.
1. Use a suitable network cable to connect the controller and your PC.
2. Open an internet browser on the PC.
3. Call up the WBM on the controller. To do this, enter the following in the
input line of the browser: "https://<IP address>/wbm".
4. If you do not know the IP address, determine the IP address as described
above.
You will then be asked to authenticate.
5. Enter the user name "user" and the corresponding password ("user" by
default).
If you have not already changed the default password, you are asked to
change the password now.
6. Open the "Configuration" tab.
7. In the navigation, select the "Networking" item and "TCP/IP Configuration"
subitem.
8. In the "TCP/IP Configuration" group, select the "Static IP" entry in the "IP
Source" selection field.
9. Enter the required IP address in the "Static IP Address" input field.
10. Enter the required subnet mask in the "Subnet Mask" input field.
11. Click the [Submit] button to apply the changes.
Changing the IP address interrupts the connection to the controller.
12. Establish a new connection with the new IP address.
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
WAGO I/O System Compact
751-9301 Compact Controller 100