Table 60: Wbm "Device Status" Page - "Network Tcp/Ip Details" Group - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100
"Network TCP/IP Details" Group
The network and interface properties of the product are displayed in this group.
Table 60: WBM "Device Status" Page – "Network TCP/IP Details" Group
Parameter
DIP Switch Status
DIP Switch Mode
DIP Switch Value
Bridge <n>
MAC Address
IP Source
IP Address
Subnet Mask
Meaning
Status of the address selection switch;
this area only appears if an address selection switch
is available.
Address Selection Switch
Off (0) IP address assignment via e.g., WBM
static Static IP address assignment via
(1 ... 254) address selection switch
dhcp Dynamic IP address assignment via
(255) DHCP
Set value of the address selection switch
Bridge currently configured;
the properties are displayed in a separate area for
each configured bridge.
MAC address used for product identification and
addressing
Current reference type of the IP address
None No IP allocation method is selected; this
occurs, for example, if a bridge was
added due to changes to the bridge
configuration.
Select a source in the Configuration tab
on the Networking > TCP/IP
Configuration page.
static IP Static IP address assignment
dhcp Dynamic IP address assignment via
DHCP
bootp Dynamic IP address assignment via
BootP (if BootP is supported)
external The IP address may be assigned by the
fieldbus application; this occurs e.g., if
the IP address is controlled by the
PROFINET application.
Current product IP address
Current product subnet mask
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 125
Manual