Removing The Female Connector; Removing The Female Connector Without Wiring; Figure 10: Removing The Female Connector Without Wiring (Application Example); Figure 11: Removing The Female Connector With Wiring (Application Example) - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100
6.4.2.2

Removing the Female Connector

WAGO recommends using a picoMAX
text as the "unlocking tool"). Further information on the unlocking tool is provided
in the Section "Accessories" > "Tools".

Figure 10: Removing the Female Connector without Wiring (Application Example)

Figure 11: Removing the Female Connector with Wiring (Application Example)

Table 43: Legend for Figures "Removing the Female Connector ..."

Position
1
2
3

6.4.2.2.1 Removing the Female Connector without Wiring

Proceed as follows to remove the female connector with the unlocking tool:
1. Place the unlocking tool (3) onto the locking latch (1).
2. Insert the unlocking tool fully.
Wedge opens locking latches (also see the figure "Removing the female
connector with wiring").
3. Grip underneath the protruding rim of the female connector (2).
4. Pull out the female connector.
Description
Male locking latch
Protruding rim of the female connector
Unlocking tool
Version 1.1.0, valid from FW Version 03.08.07(20)
unlocking tool (referred to in the following
®
Mounting 73
Manual