Installing The Upgrade Kit - Fujitsu PRIMERGY RX2530 M1 Upgrade And Maintenance Manual

9.5.6.2

Installing the upgrade kit

Figure 136: Removing the riser module support
Ê Remove the screw (1).
Ê Remove the riser module support (2).
Ê Remove the riser card from riser module 3 as described in section
"Removing the defective riser card" on page
Figure 137: Installing the riser card - example full height riser module
Ê Insert the riser card (1).
Ê Fasten the riser card with two screws (2).
Ê If applicable, install a full height slot bracket to the expansion card as
described in section
RX2530 M1
"Installing a slot bracket" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
198.
170.
205