Last Number Redial - Matrix Visionpro System Manual

Last Number Redial

This feature redials the last external number dialed from a station. This feature saves time during retrying a busy
external number. It is same as pressing the REDIAL button of the telephone instrument.
How it works
• Station A dials the command for Last Number Redial.
• The system dials the last external number dialed from station A using the same Trunk Access Code which
was used for dialing that number last time.
If station A has 'Dynamic Lock' set and accesses Last Number Redial feature, the system will check for
Toll Control as per the Lock Level set for station A before dialing out the number.
How to configure
Configure the Redial Wait Timer as mentioned below.
Redial Wait Timer
It signifies the time for which the system waits once the user dials '7'. The Auto Redial code is 77. Hence, if user
wants to try Last Number Redial on pressing '7', the system waits for Inter Digit Timer and then gives the
Confirmation Tone. This timer can be reduced to '0' if Auto Redial is not used.
To configure this timer,
• Enter SE mode.
• Dial 3034-Seconds
Where,
Default: 002 seconds.
Valid Range: 000 to 255 seconds.
• Exit SE mode.
How to use
• Lift Handset
• Dial 7 and wait.
• The system dials out the external number last dialed out from your station.
Matrix VISIONPRO System Manual 176