Matrix Visionpro System Manual page 40

• To assign the Trunk Landing Destination for Day Mode for all trunks at once, dial,
47-*-Ext1-Ext2-Ext3-Ext4
Where,
Trunk is from 0 to 2.
Ext1 to Ext4 are the flexible numbers of destination stations. Flexible number can be of 1,2,3 or 4 digits.
Maximum four destinations can be programmed for a single trunk.
For details, refer
Example:
Assign station numbers 21, 22 and 23 as the Trunk Landing Destinations for Trunk1 for Day time.
Solution. Dial 47-1- 21-22-23
Trunk Landing Destination for Night Mode
• To assign the Trunk Landing Destination for Night Mode for a trunk, dial,
48-Trunk-Ext1-Ext2-Ext3-Ext4
• To assign the Trunk Landing Destination for Night Mode for all trunks at once, dial,
48-*-Ext1-Ext2-Ext3-Ext4
Where,
Trunk is from 0 to 2.
Ext1 to Ext4 are the flexible numbers of destination stations. Flexible number can be of 1,2,3 or 4 digits.
Maximum four destinations can be programmed for a single trunk.
For details, refer
Example:
Assign station numbers 24, 25 as the Trunk Landing Destinations for Trunk1 for Night time.
Solution. Dial, 48-1-24-25
Hunt Timer
• To configure the Hunt Timer, dial,
212-Timer
Where,
Timer is from 01-99 seconds.
• For details, refer
• Hunt Timer is defined as the time for which a station rings when a trunk call lands on that station. It is
similar to the 'Ring Timer'. On expiry of the Hunt Timer, the next station of the Station Group assigned
to the trunk will start ringing.
For example, maximum four stations can be programmed for a single trunk. Now if the CO office gives
ring for 90 seconds and the Hunt Timer programmed is 18 seconds; then all four stations will ring for 18
seconds each alternately. Refer
seconds.
Matrix VISIONPRO System Manual
"Station Groups" and "Trunk Landing Groups
"Station Groups" and "Trunk Landing Groups
"Station Groups".
"Hunting Scheme"
(TLGs)".
(TLGs)".
below for more details. Default Hunt Timer is 18
34