Cli Based Routing - Matrix Visionpro System Manual

CLI Based Routing

VISIONPRO provides the facility of detecting the caller's number and presenting it on the display of the called
station. This feature is called Calling Line Identification and Presentation (CLIP).
On the basis of CLI, it is possible for calls from a particular external number to land on a particular station or a group
of stations. This is known as CLI Based Routing.
How it works
On arrival of an incoming call, the system identifies the calling party's number and compares it with the numbers in
the CLI table. The CLI table must be configured by the system engineer during programming.
If the number is present in the CLI table, the call is routed according to the CLI programmed (also known as the CLI
based routing); else the call is routed according to the Trunk Landing Group (TLG) programmed.
CLI based routing can be enabled or disabled during Day/Night time separately.
VISIONPRO offers the facility to forward a call to an external number based on the CLI numbers. Using this feature
it is possible to forward a call from a known destination to another pre-configured destination number.
• CLI based Call Forward - Trunk is possible only for the first eight indexes (00-07) in the CLI table.
• Maximum 25 CLI numbers can be routed to the desired destinations.
• If the call is routed to a station and if the station is busy/not responding, the call is routed as per the
programmed Trunk Landing Group.
How to configure
If CLI based routing is required for incoming calls, the system must be programmed as per following instructions.
• Enter SE mode.
• To enable/disable CLI based routing during Day time, dial,
1602-Code
Where,
Code Meaning
0 Disable CLI based routing
1 Enable CLI based routing
By default, CLI based routing is disabled during Day time.
• To enable/disable CLI based routing during Night time, dial,
1603-Code
Where,
Code Meaning
0 Disable CLI based routing
1 Enable CLI based routing
145 Matrix VISIONPRO System Manual