Configuring System Parameters - Matrix Visionpro System Manual

CHAPTER 9
System Parameter configuration includes commands which are executed to make system-wide changes and
access the system's version-revision information. Following feature commands are considered,
• Loading the Default Configuration
• Setting the default values to all the timers
• Configuring the Companding Type: You may select the Companding Algorithm according to the
Regulatory Requirement of the country/region where the system is installed. Default: A-law.
• Displaying the system's version and revision
How to Configure
Loading the Default Configuration
To load the default configuration of the system,
• Enter SE mode.
• Dial, 1103-Reverse SE Password.
• Exit SE mode.
On executing this command, all the programmable parameters of the system will be set to default values
as mentioned in the corresponding feature topics. However, the timings of the voice messages recorded in
the system will not be set to default.
Setting default values to all Timers
• Enter SE mode.
• Dial, 1107-*-#
• Exit SE mode.
Matrix VISIONPRO System Manual
Configuring System
Parameters
207