Matrix Visionpro System Manual page 149

Now, these groups can be allocated to the users depending upon the hierarchy of the user in the organization. A
user can be assigned different CoS groups for Day time and Night time. Once these groups are assigned to the
users, the user's CoS table would appear as shown below:
Station Number CoS Group for Day Time
00
01
02
03
04
:
:
• Maximum eight CoS groups can be formed (0-7).
• Each feature can be enabled or disabled in each group.
• The second group is the default CoS group.
How to configure
Decide the required number of CoS groups.
1.
Prepare the list of features required in each CoS group and configure it using command 4602.
2.
To restore default configuration in a CoS group, use the command 4601 (if required).
3.
Assign CoS group to a station during Day time using command 4610.
4.
Assign CoS group to a station during Night time using command 4611.
5.
On a piece of paper, chalk out the number of CoS groups to be formed and which features are to be assigned to
each group. Then configure as per above instructions,
• Enter SE mode.
• To enable/disable a feature in a CoS group, dial,
4602-1-CoS Group-Feature Index-Code
Where,
CoS Group is from 0 to 7.
Feature Index is from 00 to 30. Feature Indexes from 17 to 19 are left blank. You will get Error Tone if you
try to configure these indexes.
Code Meaning
0 Feature Disabled
1 Feature Enabled
• To enable/disable a feature in all the CoS groups, dial,
4602-*-Feature Index-Code
• To restore default configuration in a CoS group, dial,
4601-1-CoS Group-#
143
CoS Group for Night Time
7
6
4
3
6
:
:
1
4
4
3
4
:
:
Matrix VISIONPRO System Manual