Matrix Visionpro System Manual page 92

Viewing the Test Results
On successful completion of the AC Impedance test, the system provides three best matching test results for the
selected CO port. Each test result consists of the best matching codes of
and CO Line Type applicable to the selected CO port.
following format,
Result AC Termination Impedance
Index
0 Any code value between 00 - 15
1 Any code value between 00 - 15
2 Any code value between 00 - 15
To view the actual values of
each code, refer
You can view the
codes
Result Index at a time.
• To view the codes of
Result Index, dial the following command from an SLT (make sure the SLT has CLI support),
3139-Trunk-Result Index
Where,
Trunk is the software port from 0 to 2 for which the test has been conducted.
Result Index is any value from 0 to 2. Recommended is 0.
• Go ON-Hook.
• You receive an incoming ring and the codes of the dialed Result Index are displayed on the CLI of the SLT.
Make sure you note down these values on a piece of paper. You must assign them to the selected CO port.
Result Index 0 stores the best code values of
hence it is recommended that you apply these values to the selected CO port and verify the results.
Applying the Test Results
To apply the test result codes to the selected CO port,
• Enter SE mode.
• To configure the AC Termination Impedance for the trunk, dial,
3111-1-Trunk-
Where,
Trunk is the software port from 0 to 2 for which the test has been conducted.
AC Termination Impedance
Code
00
Matrix VISIONPRO System Manual
Code
AC Termination Impedance, CO Termination and CO Line Type
"Configuring Trunks".
of
AC Termination Impedance, CO Termination and CO Line Type
AC Termination Impedance, CO Termination and CO Line Type
AC Termination Impedance Code
Code is the value obtained corresponding to Result Index 0.
AC Termination Impedance

600
The system stores these codes in a specific Result Index in the
CO Termination Code
Any code value between 00 - 13
Any code value between 00 - 13
Any code value between 00 - 13
AC Termination Impedance, CO Termination and CO Line Type
AC Termination Impedance, CO Termination
CO Line Type Code
Any code value between 00 - 10
Any code value between 00 - 10
Any code value between 00 - 10
corresponding to only one
stored at a particular
corresponding to
;
86