Matrix Visionpro System Manual page 33

• Programming is accomplished by dialing separate codes (string of digits) for different settings. This
eliminates need for entering long and confusing programming sequences. Programming commands
are broken into two parts: Codes and Values.
• The system accepts and executes the command immediately, but it takes approximately 2 minutes to
save a command. So, it is advisable that you do not turn OFF the system for 2 to 3 minutes after
entering the last command.
• The system continues to function normally even during programming. This allows the SE or SA to
change the settings without disturbing any communication.
User Mode
The User mode allows any station user to set/cancel desired features by dialing specific commands from their
stations. Station users do not need to log into the SE/SA mode to access those features.
However, a User Password is provided to all station users which is a 4-digit code and used to protect PBX stations
from unauthorized access to specific features
station users from their respective stations to any desired value, not exceeding 4 digits.
If station users forget their User Password, it can be cleared and restored to the default value 1111 by the System
Engineer (SE). Refer "User Password"
3. For the list of features refer,
27
3
. The default User Password is 1111. It can be changed by the
for more details.
"User Password".
Matrix VISIONPRO System Manual