Matrix Visionpro System Manual page 191

• To configure the Service Provider (SP) sequence for the each Time Zone, dial,
3434-1-Number Index-Time Zone Index-SP0-SP1-SP2-SP3
Where,
Number Index is from 0 to 9.
Time Zone Index is from 0 to 3.
SP0: Cheapest Service Provider.
SP1: Cheaper Service Provider.
SP2: Cheap Service Provider.
SP3: Costly Service Provider.
It is mandatory to complete this command. If less number of Service Providers are used, then repeat the
cheapest Service Provider for remaining SPs.
• To default the Mixed LCR table, dial,
3431-*-#
Default Number Index is 'Blank'.
Default Time Zone is 00:00 to 23:59.
Default Service Provider sequence is from 0 to 3.
Default Mixed LCR table is shown below:
No. Index/TZ Index
00:00 to 23:59
00:00 to 23:59
00:00 to 23:59
00:00 to 23:59
• Exit SE mode.
Example 1:
• Three trunks viz. One trunk of BSNL, one of Hughes and one of Reliance are connected to the
VISIONPRO.
• BSNL is cheapest during 08.00 to 16.00 followed by Hughes and Reliance.
• Hughes is cheapest during 16.00 to 20.00 followed by BSNL and Reliance.
• Reliance is cheapest for 20.00 to 23.00 followed by BSNL and Hughes.
• BSNL is cheapest for 23.00 to 08.00 followed by Reliance and Hughes.
Service providers can be assigned SP numbers as -
BSNL = SP0
Reliance = SP1
Hughes = SP2
Use following command to assign SP number to trunks:
3402-1-0-0
3402-1-1-1
3402-1-2-2
Use following command to configure Time Zone LCR type for the Trunk Access Group:
3401-1-0-1
185
Blank Blank Blank
0 to 3 0 to 3 0 to 3
0 to 3 0 to 3 0 to 3
0 to 3 0 to 3 0 to 3
0 to 3 0 to 3 0 to 3
..... Blank
..... 0 to 3
..... 0 to 3
..... 0 to 3
..... 0 to 3
Matrix VISIONPRO System Manual