By default, code 0 is selected.
•
To configure the same CO Line Type for all trunks, dial,
3113-*-Code
•
To configure the Answer Supervision type for a trunk, dial,
3114-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2.
Code
Answer Supervision Type
0
Pseudo Answer
1
Polarity Reversal
Default code value is 0.
•
To configure the same Answer Supervision type for all trunks, dial,
3114-*-Code
•
To configure the Pseudo Answer Supervision Timer for a trunk, dial,
3117-1-Trunk-Seconds
Where,
Trunk is the software port number from 0 to 2.
Seconds is from 1 to 255 seconds.
Default is 10 seconds.
•
To configure the same Pseudo Answer Supervision Timer for all trunks, dial,
3117-*-Seconds
•
To configure the Disconnect Supervision type for a trunk, dial,
3115-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2.
Disconnect
Code
0
None
1
Polarity Reversal
2
Open Loop Disconnect
Default code value is 0.
•
To configure the same Disconnect Supervision type for all trunks, dial,
3115-*-Code
•
To configure the Open Loop Disconnect Timer for a trunk, dial,
3116-1-Trunk-Code
Where,
Matrix VISIONPRO System Manual
Supervision Type
64