Matrix Visionpro System Manual page 169

Solution. Dial following commands in SE mode,
3601-1-0-0
3602-1-0-1
4610-1-02-4
4611-1-02-7
How to use
If you are a remote user, to be able to use DOSA, you must know:
• the number of the trunk on which DOSA is enabled.
• the number of the station and the User Password which you want to access.
• the duration of the DOSA related Timers, so that you may dial digits accordingly, without delay.
• the special digits that is, '#0' to be dialed during a DOSA login session.
To access DOSA,
• Dial a DOSA activated trunk.
• On getting the PBX Dial Tone, dial 1-Station Number-User Password. You get DOSA Dial Tone (short
beeps).
• On getting DOSA Dial Tone, dial a Trunk Access Code to grab another trunk to get the P&T Dial Tone.
• On getting the P&T Dial Tone, dial the desired phone number.
• Dial any digit to continue the talk.
• Dial '#0' to disconnect the call.
• You are still logged in the system. You can make another call by grabbing P&T line.
• Dial '#0' to end the DOSA session.
163 Matrix VISIONPRO System Manual