Matrix Visionpro System Manual page 153

• To set CLI parameters to default, dial,
1601-#
On issuing above command,
• CLI based routing is turned OFF.
• All entries in the CLI table are cleared.
• Destination is cleared.
• Number string in the Call Forward - Trunk destination is also cleared.
• Exit SE mode.
CLI Based Routing Ring Timer
It specifies the time for which a station rings if the call is routed to it based on the CLI based routing.
To configure,
• Enter SE mode.
• Dial 3019-Seconds.
Where,
Default: 015 seconds.
Valid Range: 000 to 255 seconds.
• Exit SE mode.
147 Matrix VISIONPRO System Manual