Matrix Visionpro System Manual page 208

How to configure
Divide the total VM duration into required number of parts. To do that, assign the duration of each part
1.
using the command 1403. By default, each part is of equal duration, that is, 16 seconds (since, the total
VM size supported by the system is 256 seconds. So, total number of VM parts at default settings are
256/16 = 16). If required, you can configure each part of different duration and accordingly the number of
parts will also change.
Record VM for a partition (except MoH) using command 1405. However, to record the MoH, use the
2.
command 1411.
Playback the recorded message of a partition (except MoH) using command 1406. To playback the
3.
recorded MoH, use the command 1412.
Assign partition to VM application using command 1407.
4.
Default VM configuration using command 1401-#, if required.
5.
To configure as per above mentioned steps,
• Enter SE mode.
• To configure the duration of each VM part (which, in turn, also divides the total VM Duration in the desired
number of parts), dial,
1403-Index
Where,
Duration of each
Index
part (in Seconds)
1 16
2 24
3 32
4 40
5 48
6 64
7 80
8 128
By default, Index is 1.
• On dialing the above command, Confirmation Tone is played approximately after 15 seconds. Till that
time you will get silence. So, for successful application of the command, you must wait for that time
duration till the Confirmation Tone is played.
• You can change the number of voice module parts and accordingly the duration of each part except the
Music on Hold (MoH) application. Maximum duration for MoH application is limited to 16 seconds only.
• To record the VM partition (except MoH), dial,
1405-Part Number
Matrix VISIONPRO System Manual
Total Number of
Parts excluding MoH
15
9
7
5
4
3
2
1
202