Matrix Visionpro System Manual page 125

Call Forward - Trunk
To configure Call Forward - Trunk on a trunk, you must proceed as follows,
Decide the trunk whose calls are to be forwarded.
1.
Assign a Trunk Access Group to be used to forward these calls.
2.
Assign the destination number where the calls are to be forwarded.
3.
As per above instructions configure Call Forward - Trunk parameters as described below.
• Enter SE mode.
• To enable/disable Call Forward - Trunk on a trunk during Day time, dial,
3701-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2 of the trunk whose calls are to be forwarded.
Code Meaning
0 Call Forward - Trunk disabled
1 Call Forward - Trunk enabled
• To enable/disable Call Forward - Trunk on all trunks during Day time, dial,
3701-*-Code
• To enable/disable Call Forward - Trunk on a trunk during Night time, dial,
3702-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2 of the trunk whose calls are to be forwarded.
Code Meaning
0 Call Forward - Trunk disabled
1 Call Forward - Trunk enabled
• To enable/disable Call Forward - Trunk on all trunks during Night time, dial,
3702-*-Code
By default, Call Forward - Trunk is disabled on all trunks.
• To assign Trunk Access Group to forward the calls of a trunk, dial,
3703-1-Trunk-Trunk Access Group
Where,
Trunk is the software port number from 0 to 2 of the trunk whose calls are to be forwarded.
Trunk Access Group is the Trunk Access Group number from 0 to 7 through which the calls are to be
forwarded.
• To assign destination number where the calls are to be forwarded for a trunk, dial,
3704-1-Trunk-Telephone Number-#*
Where,
Trunk is the software port number from 0 to 2 of the trunk whose calls are to be forwarded.
Telephone Number is the external number (maximum 16 digits) where the calls are to be forwarded. If it
has less than 16 digits, then complete the command by dialing '#*'.
• Exit SE mode.
119 Matrix VISIONPRO System Manual