Setting The Library Fibre Channel Port 0 Address - StorageTek L700e Operator's Manual

To set the library's SCSI ID:
1. From the online status screen, press the
The Main Menu will display.
2. Press the down arrow button until the cursor underscores
CONFIGURATION.
3. Press the
The Main Configuration Menu will appear and the cursor will line up with
LIBRARY CONFIG.
4. Press the
The Lib Config Menu will appear and the cursor will line up with LIB SCSI
I/F CONFIG.
5. Press the
The Lib SCSI I/F Config Menu will appear. (This menu also displays the type
of SCSI interface: differential or single-ended.)
6. Press the arrow buttons until the cursor underscores SCSI ID.
7. Press the
The Set Lib SCSI ID Menu will appear.
8. Press the up and down arrow buttons to select the correct ID.
9. Press the
button to abort.)
10. If the library SCSI ID is the only configuration value you wish to set at this
time, press the
before you reset the library, continue with the next section.

Setting the Library Fibre Channel Port 0 Address

If the control path for the library is Fibre Channel, you must set the Library's
Fibre Channel Port 0 address. The library Fibre Channel Port 0 address locates
the library's Port 0 on the Fibre Channel loop. Set the library Fibre Channel Port
0 address from the Lib Fibre I/F Config Menu.
Note: Before you enter a Port 0 address, you must first set the library's Fibre
95845
4. If you use Automated Cartridge System Library Software (ACSLS), its
level must be Version 5.3.2 or higher
button.
SELECT
SELECT button.
button.
SELECT
button.
SELECT
button to save the changes. (You may press the
SELECT
button. If you wish to set other configuration values
RESET
Channel hard address option to enabled.
If you configure the library for soft addressing, you are allowing the
network's software to configure the Port 0 address. For this addressing
approach, you must set the Fibre Channel hard address option to
disabled.
Tenth Edition
Entering Configuration Data
button.
MENU
MENU
3-5