Csl In Manual Mode; Cartridge Removal From Feed Channel; Figure 5-16. Cartridge Stop Mechanism - StorageTek 9840 Product Manual

Modes of Operation
.

CSL in Manual Mode

This mode is used for sequential mounting of cartridges from the input bin into
the drive. The operator controls each mount by pressing the
each mount. When the CSL is in the manual mode and the drive is not loaded,
follow these procedures to load a priority cartridge:
1. If there are no cartridges in the input bin, the
signaling you to put a cartridge into the feed channel.
2. Press the
Note: Refer to

Cartridge Removal from Feed Channel

If the output bin is full (seven cartridges), and you load an eighth cartridge into
the feed channel for a priority mount, the cartridge cannot eject into the output
bin. The cartridge ejects into the feed channel
physically remove the cartridge from the feed channel.
Follow these instructions to remove the eighth cartridge from the feed channel:
1. Remove all cartridges from the input and output bins.
2. Push the cartridge stop mechanism down
3. Grasp the cartridge and remove it from the feed channel.

Figure 5-16. Cartridge Stop Mechanism

1. Cartridge
2. First index rod
3. Cartridge stop mechanism
5-22
switch to resume CSL operation.
Start
Figure 5-15 on page 5-21
feed channel.
3
Sixth Edition
Start
indicator flashes
operator
to correctly load a cartridge into the
(Figure 5-16). You must
(Figure 5-16).
1
2
C53665
switch before
95741