OE Max Controls CSDJ Plus User Manual page 46

Circuit Breaker
CSDJ Plus Servo Drive uses general power source (Single phase
220VAC, 50/60Hz). For system protection from grounding accident,
contact accident, electric leakage and the case of the fire, install the CP
(Circuit Protector) or the fuse with capacity provided in the table
below.
In case of using several servos, circuit breaker for wiring could be
shared. The capacity of the circuit breaker should be set by the total
amount of servo drive capacity.
Table 2.8 Capacity of Circuit Breaker and Fuse
Power
Servo Drive
Supply
CSDJ-01BX2
CSDJ-02BX2
220VAC CSDJ-04BX2
CSDJ-06BX2
CSDJ-10BX2
1. Data in above table are the rated load capacity.
2. Over-current feature (25℃) : Over 200%/2sec, over 700%/0.01sec.
3. DAERYUK DCP-50BH Series(UL).
http://www.dacb.co.kr
Since the inrush current flows when the CSDJ Plus Servo
Drive capacitor power is charged, do not use the high
speed-break fuse.
Also, for checking up on an accidents, use NFB (No Fuse
Breaker) in power input wire.
Servo Drive MCCB/FUSE Current
Capacity
Power
Capacity (KVA)
0.286
0.44
0.726
1.54
1.716
NFB
Capacity
(A)
220V/3A
220V/6A 30A
220V/9A
220V/14A
Inrush
Current
30A
2-23