OE Max Controls CSDJ Plus User Manual page 115

Speed/Multi Step Speed Control Mode
It may be converted to speed/multi step speed control mode by ON/
OFF of
Table 6.4 Speed/Multi Step Speed Control Mode Setting
Item
Mode Setting
Parameter
P-CON Input Terminal
Control Mode
OFF → Speed Control Mode
Conversion
ON → Multi Step Speed Control Mode
Selection by P-CL, N-CL Input Terminal
Multi Step Selection
Speed
In order to set direction conversion command terminal
with CN1 pin 10 or 15, set '3' in SEt-46 LED No. 4 or 5.
Forward/Reverse direction command is operated through
ON/OFF of set terminal (CN1. 10 or 15)
Acceleration time: Setting value of Set-19
Deceleration Time: Setting value of SEt-20
Acceleration and
Unit: msec
Deceleration time in
Caution : Acceleration and deceleration time must be
mode Conversion
* Step 4 speed can be used when selecting multi step speed
control mode. Refer to next page for its usage.
ON: The corresponding input terminal is connected to input voltage
GND(0V)
OFF: The corresponding input terminal is connected to +24VIN or not
connected.
input terminal.
P-CON
Description
SEt-41 = 14
---- ----
Item
P-C L N-C L
Step 1 spee d
OFF ON
Step 2 spee d
ON OFF
Step 3 spee d
ON ON
Stop
OFF OFF
set. In case of which the acceleration and
deceleration time is "0", it may be too harsh for
the load during control mode conversion.
Setting value is effective
after Power ON/OFF .
Speed Val ue
Setting val ue of
SEt-2 6
Setting val ue of
SEt-2 7
Setting val ue of
SEt-2 8
0
Note
6-9