Fig 6.4 Multi Step Speed Control Circuit - OE Max Controls CSDJ Plus User Manual

When the speed command desired by the user is not in the multiples
of 10, set to LED No.2=1 of SEt-46 and change the unit of the value to
[RPM/10V]. When setting SEt-01=1553, motor is rotated in 1553[RPM]
with 10V speed command.
SEt-01
SEt-46 LED No.2
[RPM] = 300[RPM/10V] x10[V]
Thus when setting 10V, motor rotates in 3000RPM.
Multi Step Speed Control Mode
Used when desired to operate the motor in the speed already set
(forward/reverse 3 types of speed).

Fig 6.4 Multi Step Speed Control Circuit

Table 6.3 Multi Step Speed Control Mode Setting
Multi Step Speed Control Mode Setting
Speed Value Setting
Speed Command Selection
Forward/Reverse Command
Acceleration Time Setting
Deceleration Time Setting
* Current limit function and P/PI control conversion function
* When using the acceleration/deceleration function. Shock on the
300
0
cannot be used here.
system can be reduced during speed change.
SEt-01
SEt-46 LED No.2
[RPM] = 2439[RPM/10V] x10[V]
Thus when setting 10V, motor rotates in 2439RPM.
Setting Value of SEt-41 = 3
Setting Value of SEt-26, SEt-27, and SEt-28[RPM]
P-CL(CN1 Pin 9), N-CL(CN1 Pin 8)
P-CON Terminal (CN1 Pin 6)
Setting Value of SEt-19[msec]
Setting Value of SEt-20[msec]
2439
1
6-7