OE Max Controls CSDJ Plus User Manual page 33

2-10
- When the product must be installed at a location with vibrations,
use the vibration-absorbing device, so it does not affect the servo
drive directly.
- When corrosive gas exists in the surrounding, NFB, terminal block,
and etc. may be rusted and connection defect may occur. This can
be the cause of unexpected accidents. Avoid the usage in locations
with high temperature, humidity, dust, iron, explosive gas, and etc.
Installation Environment
- Install the product in the environment with the following
specifications.
- Indoors where there is no corrosive or explosive gas.
- Ambient temperature: 0 ~ +55℃
- Storing temperature: -20 ~ +80℃
- Humidity: 20 ~ 80% (non-condensing)
- Vibration: 0.5G (4.9m/s
- Place with good ventilation and no dust and humidity.
- Place where maintenance and cleaning is easy.
- If there are water and oil drops in the surrounding, take appropriate
action such as using cover etc.
Other Precautions
- Install the system with the following precautions.
• Mount the product vertically on the wall using the bolt hole on
the sides.
• For the natural cooling effect, provide sufficient space around
the system.
• When series of servo drives are mounted in the panel,
temperature distribution of the panel may not be uniform and
this may cause the temperature rise.
- In such cases, install the cooling fan in the upper area of the panel
as shown in Fig 2.6 and lower the temperature of the servo drive.
2
) or less