OE Max Controls CSDJ Plus User Manual page 21

Operating Temperature/
Storing temperature/
Vibration/Shock Resistance
Position
Protection Function
D/A
Output
External
Display
External
Communi
cation
* 1) The Servo drive has the built- in DC power (300 V), thus separate DC power supply is not needed. (except the
DC 24V power for external I/O.)
* 2) Refer to Encoder Type Setting (SEt-51)
* 3) Number of pulse greater than the number of encoder pulse cannot be output in one rotation of the motor.
* 4) Regeneration energy is generated when motor decelerates. Regenerative energy, which can be absorbed
just by the drive and the motor, differs according to the rotation speed and load inertia of the motor. Refer to
Allowable Load Inertia
1-6
Standard Specifications
Table 1.1 Standard Specifications of CSDJ Plus Servo Drive
*1
Power Source
Control Method
*2
Encoder
Humidity
Humidity
Output Spec.
Freq. Dividing
*3
Ratio
External Input
External Output
Dynamic Brake
*4
Regeneration
Speed
Troque
LED
Operator
PC-Software
Single phase 220V + 10, -15% 50/60Hz
PWM control using IPM
2048 P/R (Incremental type)
0°C~+55°C / 90% or less(non-condensing)
-20°C~+80°C / 90% or less (non-condensing)
Vibration 0.5G / Below shock 2G
(1G = the acceleration of gravity. : 9.8m/s
Encoder A, B, Z pulse output (MC3487 line driver)
N/M (N, M ≤ 8192)
Servo On/Off, P control, Forward/Reverse rotation prohibition,
Forward/Reverse rotation current limit, Alarm Reset.
Brake control, Servo Alarm/Code(3bit),Speed Coincidence(Speed
Control Mode), Position Completion(Position Control Mode),
Z-Pulse(Open- Collector)
Over-current, Overload, Over-voltage, Over speed, Inverter overheat,
low voltage, CPU defect, Encoder defect, Communication error, and
etc.
Operating when Servo/Controller Off or Alarm (Built-in)
External auxiliary capacitor in case of 400W or less.External
Regeneration resistor in case of 600W or more.(It can be connected
if necessary)
±
1V/the value of SEt-08 [RPM] (max.
±
1V/ the value of SEt-09 [%] (max.
Power on, Servo run, Servo Alarm (applied in all models)
Speed/Torque/Position command value, Electrical/Mechanical angle,
Error value, Feedback value, Offset value, Load inertia ratio I/O status
monitoring and etc.
All function of the operator
2
)
±
10V)
±
10V)