OE Max Controls CSDJ Plus User Manual page 101

Parameter
SEt-10
SEt-12
SEt-14
SEt-11
SEt-13
SEt-15
SEt-64
SEt-65
-
5 15
Parameter Setting Related to Torque Limit
Name
Forward Rotation Torque
Limits the torque in set value.
Limit
100% : Rated torque of the motor
External Current Limit of
Forward Rotation
- P-OT is set in forward rotation prohibition
P-OT signal is input during the forward
rotation of the motor, the motor is
Emergency Stop Torque
emergency stopped. This sets the
of Forward Rotation
emergency stop torque value at this
moment.
- 100% : Rated torque of the motor
* Refer to Auto Zero-Clamp Speed Control
Reverse Rotation Torque
Limits the torque according to the setting.
Limit
100% : Rated torque of the motor
External Current Limit of
Reverse Rotation
- N-OT is set in reverse rotation prohibition
Emergency Stop Torque
of Reverse Rotation
- Set when the load rise as the motor
- It is possible to make up for the problem
Forward Torque Offset
Note: When using with SEt-65, SEt-64 can
- Sets when the load rises when the motor
- It is possible to make up the problem,
Reverse Torque Offset
Note: When using with SEt-64, SEt-65 can
Description
External current limit of
ON
------
forward rotation is effective.
P-CL
Setting value is ineffective.
(CN1 9)
OFF (Setting value of SEt10 is
effective).
signal (LED No.2=0 of SEt-43), and if the
Mode .
External current limit of
ON
reverse direction is effective.
------
N-CL
Setting value is ineffective.
(CN1 8)
OFF (Setting value of SEt11 is
effective).
signal(LED No.3=0 of SEt-43), and if N-OT
signal is input during the reverse rotation
of the motor, the motor is emergency
stopped. This sets the emergency stop
torque value at this moment.
rotates forward towards the vertical axis
of the load.
which the load falls when unlocking the
machine brake in servo on state, in the
load which is operating to the vertical axis
not be non-zero when SEt-65 is also
non-zero.
rotates reverse towards vertical axis of
load.
which the load falls when unlocking the
machine brake in servo on state, in the
load which is operating to the vertical
axis.
not be non-zero when SEt-64 is also
non-zero.
Setting Factory
Unit
Range Setting
% 0~300 300
% 0~300 100
% 0~300 300
% 0~300 300
% 0~300 100
% 0~300 300
% 0~ 0
100
% 0~ 0
100