OE Max Controls CSDJ Plus User Manual page 36

Wiring Diagram
Fig 2.8 Wiring Diagram
1. Photo Coupler output capacity is below DC 30V 50mA.
2. Connect when utilizing absolute encoder.
3. When external power is above 5V, connect external
resistor. System is tolerant to the noise if 24V power is
used. (Refer to "Wiring").
Twisted pair shield wire must be used for position
command pulse.
4. Alarm reset is effective only when the terminal is on.
(This is Edge detection, not the Level.)
5. The function differs according to the setting value of
SEt-46 LED No.4 and 5. The image above represents
the function according to the initial value set in SEt-46
LED No.4 and 5. Refer to User Parameter.
2-13