Parameter Control Commands; Set" And "Show" Command Examples - Avaya AP-3 User Manual

Parameter Control Commands

The following sections cover each CLI Command, and include several
tables showing parameter properties. The two Parameter Control
Commands are show and set. These allow you to view (show) all
parameters and statistics and to change (set) parameters.
• show - To see any Parameter or Statistic values, you specify a single
parameter, a Group, or a Table.
• set - Use this CLI Command to change parameter values. You can
use a single CLI Statement to modify Tables, or modify each
parameter separately.

"set" and "show" Command Examples

In general, you will use the CLI "show" Command to view current
parameter values, and use the CLI "set" Command to change parameter
values. As shown in the following six examples, parameters may be set
individually, and all parameters for a given table can be set with a single
statement.
Example 1 - Set the Access Point IP Address Parameter
Syntax:
[Device Name]>set <parameter name> <parameter value>
Example:
[Device Name]> set ipaddr 10.0.0.12
Avaya Wireless AP-3 User's Guide
CLI Command Types
6-23