Download A New Image Using The Bootloader Cli - Avaya AP-4 User Manual

Recovery Procedures
7. Enter the network's Subnet Mask in the field provided.
8. Enter the network's Gateway IP Address, if necessary. You may
need to contact your network administrator to get this address. You
should only need to enter the default gateway address if the
Access Point and the TFTP server are separated by a router.
9. Enter the IP address of your TFTP server in the field provided.
10. Enter the Image File Name (including the file extension). Enter the
full directory path and file name. If the file is located in the default
TFTP directory, you need enter only the file name.
11. Click OK.
— Result: The Access Point will reboot and the download will
begin automatically. You should see downloading activity
begin after a few seconds within the TFTP server's status
screen.
12. Click OK when prompted that the device has been updated
successfully to return to the Scan List screen.
13. Click Cancel to close the ScanTool.
14. When the download process is complete, configure the AP as
described in

Download a New Image Using the Bootloader CLI

To download the AP Image, you will need an Ethernet connection to the
computer on which the TFTP server resides. This can be any computer
on the LAN or connected to the AP with a cross-over Ethernet cable.
7-22
Getting Started and Advanced Configuration.
Avaya Wireless AP-4/5/6 User's Guide