Viewinstalledboard; Viewfirmwareforallcontrollers; Restartthedevice; Queryhealthstatus - Lightware HDMI-TPS-TX210 User Manual

   
6.LW2Programmer'sReference
6.3.7. View Installed Board
Showsthehardwarenameandrevisionoftheinstalledcard.
Command and Response
 {IS}
 (SL#•0•<MB_DESC>)CrLf
 (SL•END)CrLf
Example
 {is}
 (SL#0SW4-TPS-TX240V12_DAA0)
 (SLEND)
The device reports its motherboard (slot 0).
6.3.8. View Firmware for All Controllers
DIFFERENCE:
This command has been changed in firmware package v1.2.0. The response was the
firmwareoftheCPUinthepreviousfirmwares.
Showsthefirmwarepackageversionsofallinstalledcontrollers.
Command and Response
 {FC}
 (CF•<DESC>)CrLf
 (CF•<DESC>)CrLf
 ...
 (CF•END)CrLf
Parameters
<FW_VER>isthefirmwareversion.Itisfollowedby<s>stringwhichmayindicatespecialversions.
Example
 {fc}
 (CFSW4-TPS-TX240-Plus1.2.0b12r25)
 (SLEND)
The device has one control panel.
#firmwareversion
HDMI-TPS-TX200series–User'sManual
6.3.9. Restart the Device
Thedevicecanberestartedwithoutunpluggingpower.
Command and Response
 {RST}

Example
 {rst}

Thedevicereboots;noresponseissentinthiscase.
6.3.10. Query Health Status
Internalvoltagesandmeasuredtemperaturevaluesareshown.
Command and Response
 {ST}
 (ST•<DESC>)CrLf
Example
 {st}
 (STCPU11.61V5.03V1.84V1.28V0.99V42.24C42.23C)
6.3.11. Restore Factory Default Settings
Settingscanberesettofactorydefaultvaluesasfollows:
Command and Response
 {FACTORY=ALL}
 (FACTORYALL...)CrLf
Example
 {factory=all}
 (FACTORYALL...)
Allsettingsandparametersareresettofactorydefault,seethetablein the
Appliedfirmwarepackage:v1.2.0 | LDCsoftware:v2.2.0
59
#reboot #restart
#factory
FactoryDefaultSettings section.