Task Stop; Syntax; Parameters; Switches - Adaptec RAID 2810SA Software Reference Manual

task stop

To stop one or all tasks running on the currently opened controller,
use the task stop command.

Syntax

task stop [/all{=boolean}]

Parameters

{integer}
Specifies the task ID for the task to stop. Perform a task list
/all to display the task IDs for all tasks currently running on
the open controller before stopping a specific task or all tasks.

Switches

/all{=boolean}
Specifies whether to stop all running tasks. If you set this
switch to TRUE, the command stops all tasks that were running
on the currently opened controller.
If you do not specify this switch or a valid task ID, the
command displays an appropriate error message.

Examples

Before stopping a running task, use the task list command to
identify any currently running tasks, as in the following example:
AAC0>task list
Executing: task list
TaskId Function Done% Array
------ -------- ----- ---------
101 Scrub 24.6%
The following example shows the use of the task stop command
to stop task 101:
AAC0> task stop 101
Executing: task stop 101
Use the task list command after using the task stop
command to display information about the task, as in the following
example:
State Specific1
----- ---------
0 RUN 00000000
task Commands
Specific2
---------
00000000
9-10