Adaptec RAID 2810SA Software Reference Manual page 67

AAC0>container create raid5 /stripe_size=64K /scrub
((0,02,0),10M) (0,03,0) (0,04,0) (0,05,0)
Executing: container create raid5 /stripe_size=65,536
scrub=TRUE ((CHANNEL=0,ID=2,LUN=0),10,485,760 )
(CHANNEL=0,ID=3,LUN=0) (CHANNEL=0,ID=4,LUN=0)
(CHANNEL=0,ID=5,LUN=0)
container 0 created
As the command executes, note that the title bar of the MS-DOS
window displays the status of the command. For example:
Stat:OK!Task:101,Func:R5S Ctr:0,State:RUN 84.6%
See page 3-10 for detailed information on the status information that
the command displays in the title bar as it executes the task.
On UNIX systems, the message displayed after you execute the
container create raid5 command includes the root special
file associated with the newly created RAID-5 set.
Use the container list command after using the
command to display information about the RAID-5
create raid5
set.
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 RAID-5 30.0MB
The following list describes the columns that contain information as
a result of creating a RAID-5 set with the container create
raid5 command:
The Num Label column displays the ID number of the newly
created RAID-5 set, which in the example is 0.
If you specify a label when creating the RAID-5 set, it appears
in this column. Because no label was specified when the RAID-
5 set was created, no label appears in the column.
On UNIX systems, the root special file associated with the
RAID-5 set also appears in this column.
Scsi Partition
Usage C:ID:L Offset:Size
64KB None 0:02:0 64.0KB:
0:03:0 64.0KB:
0:04:0 64.0KB:
0:04:0 64.0KB:
container Commands
/
container
10.0MB
10.0MB
10.0MB
10.0MB
5-28