Examples
Before renumbering an array, use the container list command
to obtain information about any existing arrays. As the following
example shows, there is an array 0 (a volume set) on this controller:
AAC0>container list
Executing: container list
Num
Total
Oth Stripe
Dr Label Type
Size
Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0
Volume 20.0MB
The following example renumbers array 0 to array 5:
AAC0>container move 0 5
Executing: container move 0 5
Use the container list command after using the container
move command to display information about the array you just
renumbered, as in the following example:
AAC0>container list
Executing: container list
Num
Total
Oth Stripe
Dr Label Type
Size
Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 5
Volume 20.0MB
As a result of renumbering array 0 to array 5 with the container
move command, the Num Label column displays ID number 5
instead of 0. This column also displays the label assigned to the
array when the array was created. If no label was assigned to the
array then no label appears in the column.
Related Information
container commands:
container list
Scsi
Partition
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
0:03:0 64.0KB:
Scsi
Partition
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
0:03:0 64.0KB:
(page
5-54)
container Commands
10.0MB
10.0MB
10.0MB
10.0MB
5-68