Related Information - Adaptec RAID 2810SA Software Reference Manual

The following example shows how to unmirror a mirror set from the
mirror set that resides on SCSI device (0,3,0):
AAC0>container unmirror 0
Executing: container unmirror 0
Note that the example eliminates some items in the container
list display so that you can see an example of the State column.
The following list describes the changes to the display as a result of
using the container unmirror command:
The Type column displays Volume, which indicates that the
mirror set was created from a Volume set.
The State column displays a blank space instead of Normal.
The Normal state is displayed only for mirror sets.
The Scsi C:ID:L column displays only one SCSI ID.
The Partition Offset:Size column displays only one partition
offset and size.
If a partition is dead, the ":" (colon) in the Partition Offset:Size
column changes to a "!" (exclamation point). See the disk
remove dead_partitions
more information on dead partitions.

Related Information

container commands:
container create mirror
container list
disk commands:
disk remove dead_partitions
(page 7-9)
(page 5-5)
(page 5-54)
(page
container Commands
command for
7-9)
5-120