Container Unlock; Syntax; Parameters; Examples - Adaptec RAID 2810SA Software Reference Manual

container unlock

Caution:
Use the container unlock command only
!
under the direction of Technical Support.
To unlock an array so it can be moved, deleted, made read-only, and
used to create a multilevel array, use the container unlock
command.

Syntax

container unlock {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the array to unlock.

Examples

Before unlocking an array, use the container list command
(with the /full switch) to obtain information about any existing
arrays. As the following example shows, there is an array 0 (a
volume set) on this controller. Note that the Lk column displays an
L, which indicates that array 0 was previously locked with the
container lock command:
AAC0>container list /full
Executing: container list /full=TRUE
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- --------
F: 0 Volume 10.0MB
Note that the example eliminates some items in the container
list display so that you can see an example of the Lk column.
container Commands
Scsi
Usage C:ID:L Lk
--
NTFS 0:02:0 L
5-117