Adaptec RAID 2810SA Software Reference Manual page 119

/raid5{=boolean}
Specifies whether to reconfigure the existing array into a
RAID-5 set. If you specify TRUE, the command reconfigures
the existing array into a RAID-5 set. If you specify FALSE, the
command does not reconfigure the existing array into a RAID-
5 set.
This switch defaults to FALSE.
/raid10{=boolean}
Specifies whether to reconfigure the existing array into a
RAID-10 set. If you specify TRUE, the command reconfigures
the existing array into a RAID-10 set. If you specify FALSE, the
command does not reconfigure the existing array into a RAID-
10 set.
This switch defaults to FALSE.
/stripe{=boolean}
Specifies whether to reconfigure the existing array into a stripe
set. If you specify TRUE, the command reconfigures the
existing array into a stripe set. If you specify FALSE, the
command does not reconfigure the existing array into a stripe
set.
This switch defaults to FALSE.
/volume{=boolean}
Specifies whether to reconfigure the existing array into a
volume set. If you specify TRUE, the command reconfigures
the existing array into a volume set. If you specify FALSE, the
command does not reconfigure the existing array into a
volume set.
This switch defaults to FALSE.
container Commands
5-80