arcconf setstatsdatacollection
Enables or disables statistics collection for a controller. To display the statistics, use the
getlogs
command (see
Syntax
ARCCONF SETSTATSDATACOLLECTION <Controller#> Enable|Disable
Parameters
Controller# is the controller number.
Enable turns statistics collection on.
Disable turns statistics collection off.
Example
ARCCONF SETSTATSDATACOLLECTION 1 ENABLE
arcconf task
Performs a task on a logical drive or a physical drive.
Syntax
ARCCONF TASK
TASK START <Controller#> LOGICALDRIVE <LogicalDrive#> <options> [noprompt]
TASK STOP
<Controller#> LOGICALDRIVE <LogicalDrive#>
TASK START <Controller#> DEVICE <Channel> <ID> <options> [noprompt]
TASK STOP
<Controller#> DEVICE <Channel> <ID>
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive in which the task is to be performed
Logical drive options:
●
verify_fix (Verify with fix)—verifies the logical drive redundancy and repairs the drive if
●
bad data is found.
verify—verifies the logical drive redundancy without repairing bad data.
●
clear—removes all data from the drive.
●
Physical device options:
●
verify_fix—verifies the disk media and repairs the disk if bad data is found.
●
verify—verifies the disk media without repairing bad data.
●
clear—removes all data from the drive.
●
initialize—returns a drive to the READY state (erases the metadata).
●
secureerase [password]—removes all data from the drive in a secure fashion to prevent
●
any possible recovery of the erased data. See
about setting the password.
Examples
ARCCONF TASK START 1 LOGICALDRIVE 1 VERIFY
ARCCONF TASK START 1 DEVICE 0 0 INITIALIZE
Chapter 2: Using the Command Line Utility
page
18).
arcconf atapassword on page 14
30
●
arcconf
for details