Related Information - Adaptec RAID 2810SA Software Reference Manual

The State column displays Normal for arrays 0, 63, and 62 to
indicate that the state of the array is normal.
Note that this column appears only if you specify the /full
switch with the container list command.
The Scsi C:ID:L column displays the SCSI device ID for the
disk on which you created the multilevel stripe set. It also
displays the SCSI device ID(s) for the disk(s) on which the
array(s) that make up the multilevel stripe set reside. In the
example, the display shows that array 63's partitions are on
SCSI disk 0:02:0. array 62's partitions are on SCSI disk 0:03:0.
The Partition Offset: Size column displays the partition offset
and the size of the arrays that make up the newly created
multilevel stripe set. In the example, the display shows that
array 63 has partition offsets of 64.0 KB and 15.0 MB and sizes
of 15.0 MB. array 62 has partition offsets of 64.0 KB and 15.0
MB and sizes of 15.0 MB. You specify the partition offset and
size when you create the array.

Related Information

container commands:
container create mirror
container list
container set label (
(page 5-5)
(page 5-54)
)
page 5-107
container Commands
5-18