Parameters; Switches - Adaptec RAID 2810SA Software Reference Manual

Parameters

{container}
Specifies the ID number (0 to 63) of the array from which you
want to create the multilevel stripe set.
{container}...
Specifies the ID number or numbers (0 to 63) of one or more
arrays from which you want to create the multilevel stripe set.
You can use up to 16 arrays to create a multilevel stripe set. All
specified arrays must be the same size as the first
parameter and separated by blank spaces.

Switches

/stripe_size{=integer}
Specifies the stripe size for the multilevel stripe set. Valid
values are 16 KB, 32 KB, and 64 KB.
If you do not specify the switch, it defaults to 64 KB.
/label{=string}
Specifies a label to be assigned to the newly created multilevel
stripe set. You can specify a maximum of sixteen characters for
the label.
If you do not specify the switch, it defaults to no label. If you
do not specify a label, you can do so later by using the
container set label command.
container Commands
container
5-15