controller firmware update
To update a controller's flash components from the flash image data
in a pair of user flash image (UFI) files, use the controller
firmware update command. This command can update the flash
components on a single controller or multiple controllers.
Syntax
controller firmware update
[/C[{controller_ID}][{controller_ID}...]
{/D{UFI_file_path}]
Switches
/C{controller_ID}
Specifies the controller ID representing the set of controllers on
which to perform the firmware update.
If you do not specify this switch, the firmware update is
performed on controller 0.
/D{UFI_file_path}
Specifies the path where the pair of UFI files are located.
If you do not specify this switch, this command looks for or
creates a pair of UFI files in the current default drive and
directory.
Examples
The following example updates a controller's firmware.
AAC0> controller firmware update D:\...
Executing: controller firmware compare "D:\..."
!!The controller's firmware has been successfully updated; you need to
restart the system!!.
Related Information:
controller commands:
controller firmware compare
controller firmware save
controller Commands
(page
6-6)
(page
6-7)
6-9