Adaptec RAID 2810SA Software Reference Manual page 118

This switch applies only to those multilevel volume sets on
which an NTFS file system resides. If you extend an NTFS file
system, you must reboot your system in order for the extension
to take effect.
If you do not specify this switch, you can later extend the file
system with the container extend file_system
command.
This command and its associated switches (if any) are supported on
the following operating systems:
Windows NT
Windows 2000 (basic disk only)
Windows XP (basic disk only)
/mirror{=boolean}
Specifies whether to reconfigure the existing array into a
mirror set. If you specify TRUE, the command reconfigures the
existing array into a mirror set. If you specify FALSE, the
command does not reconfigure the existing array into a mirror
set.
This switch defaults to FALSE.
/partition_move{=boolean}
Specifies whether to move partitions instead of adding extra
space (using additional disks). If you specify TRUE, the
command moves partitions instead of adding extra space. If
you specify FALSE, the command does not move partitions.
This switch defaults to FALSE.
/partition_size{=integer}
Specifies the partition size. All partitions must be the same size
and you can specify only one partition per disk.
container Commands
5-79